Baileigh Industrial B8550, Operator'S Manual

Page: 25 / 44

23
23
LUBRICATION AND MAINTENANCE
•
Check daily for any unsafe conditions and fix immediately.
•
Check that all nuts and bolts are properly tightened.
•
On a weekly basis clean the machine and the area around it.
•
Lubricate threaded components and sliding devices.
•
Apply rust inhibitive lubricant to all non-painted surfaces.
•
The gearbox oil should be changed every three years, with 80 W90 gear lube. (1.5 – 2 years
if used more than 12hrs/day).
• Periodically lubricate the "V" rollers and rear cam rollers with light machine oil.
• Be sure to keep the slide ways clean and the gib screws properly adjusted.
• Be sure always to use sharp cutters, dull or worn tools will decrease the performance of the
machine and may be unsafe.
•
Periodically check the power cord for cuts or bare wire and replace if damaged.
Oil Disposal
Used oil products must be disposed of in a proper manner following your local regulations.
Storing Machine for Extended Period of Time
If the Vertical Milling Machine is to be inactive for a long period of time, prepare the machine as
follows:
• Disconnect the electrical supply from the power panel.
• Empty and clean the coolant reservoir.
•
Clean and grease the machine.
•
Cover the machine.
Note : Proper maintenance can increase the life expectancy of your machine.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.