Baileigh Industrial B8075, Operator'S Manual

Page: 21 / 55

18
18
3. Install and tighten the 1/2-13 socket head
bolts provided with the die. Tighten these
bolts enough to hold the die firmly down to
the spindle. Approximately 30-40ft-lb. (40-
50N•m).
IMPORTANT:
FAILURE TO
PROPERLY BOLT DOWN DIE WILL RESULT
IN DAMAGE TO MACHINE AND TOOLING.
4. To install the counter die, remove the hitch
pin (H) and insert the counter die in the
opening in the counter die mount until the
3/4” holes line up.
5. Now insert the hitch pin through all the holes.
6. The counter die should be positioned
approximately 1/8” (3mm) away from the die.
This is accomplished by a combination of the
slide plate position and changing between
the two provided quick releases. See the
Counterdie Placement Chart near the end of
the manual.
7. In combination, install the recommended
quick release (silver or gold) and then position the slide plate in the recommended holes.
8. Tighten the two socket head bolts to 200lbf ft. (27Nm).
IMPORTANT:
The two 3/4-10 bolts hold the slide plate mechanism in place against the
force generated during bending. Use the supplied wrench plus any needed assistance to
achieve the proper torque.
H