Bahco BBH12-1200, Owner'S Manual

Page: 5 / 100

•
5
•
4.2. Standard Mode:
1. Connect the clamps to the battery terminals. The BBH12-1200 Hybrid Booster
will automatically turn on. The digital display will show the voltage of the vehicle’s
battery.
2. Press ON/OFF, the BBH12-1200 Hybrid Booster will start to recharge the
ultracapacitors inside your booster. The digital display shows the charging
percentage of the ultracapacitors and the 'CHG%' indicator will start to blink.
3. When the digital display shows FUL or gets 100%, and the condition indicator is
steady green, turn on your vehicle's engine.
4.3. Override mode:
This mode is used when there is no battery mounted on your vehicle or when your
vehicle’s battery is completely flat. Connect the BBH12-1200 Hybrid Booster as shown
below:
1. Press the ON/OFF switch for 2 seconds and then release it. The back-up lithium
battery will start to recharge the ultracapacitors inside your BBH12-1200 Hybrid
Booster.
2. After the digital display shows FUL or gets 100%, press the ON/OFF button for
2 seconds and then release it.
3. The 'Condition Indicator' will start blinking in green for 5 seconds.
4. After the 'Condition indicator' is steady green, the device emits a Bip, and
signal showing on the display, you have 30 seconds to turn the
engine on. Once the OVr display signal disappears, the Override mode will stop
automatically working.