Press and hold the button to turn on the
500C backlight screen. If a headlight is
installed, this will also turn on the light. To
turn it off, press and hold the button
again.
Press and hold the button to activate
walking assist mode. The pedal assist level
displayed on the screen will change to P
and the motor will move the bicycle at
about 4mph.
You need to keep holding down the
button until you are done wanting to use
the walk assist. To turn off the walk assist,
let go of the button.
FUNCTION OVERVIEW
1
ON/OFF:
Install the 500C display on the handlebar and adjust to your desired location, then secure
tightly with the supplied bolt.
FUNCTION OVERVIEW
To turn the unit on, press and hold the
power button to start the display. Press
and hold the power button again to
switch it off.
Note:
• The battery must also be turned on (if
applicable).
• If the display is secured with a
password, you will need to input the
password before operating the unit.
• The display will automatically shut down
after few minutes of inactivity or ride.
2
Pedal Assist Level:
The display unit provides several levels of
power. Press the or button to increase
or decrease the power and speed levels.
When the display is powered ON, the
default PAS level is 0.
Note: Increasing your PAS level provides
more power and speed.
3
Speed & Mileage Mode Switch:
Press the button on the underside of the
display to cycle through the information
data available. Toggle between single-trip
distance (TRIP), riding time (TIME), total
distance (ODO), average speed (AVG), and
maximum speed (MAX).
If there is no operation for 5 seconds,
display will automatically return to TRIP.
5
Walk Assist Mode:
4
Headlight/Backlight Display:
5
500C
MANUAL
© Copyright Ebike Essentials. All Rights Reserved.
www.Bafangusadirect.com