BAFANG DP C10.UART, User Manual

Page: 19 / 21

19
6 Error Code Definitions
The DP C10.UART can show e-bike faults. When a fault is detected, the icon will
be displayed. In the speed field one of the following error codes will be displayed:
Error Code Error Description Error-shooting Method
“03” Brake enabled Check whether a brake cable is stuck
“04” The throttle has not returned home Check if throttle has returned home
“05” Throttle fault Check the throttle
“06” Low voltage protection Check the battery voltage
“07” Overvoltage protection Check the battery voltage
“08” Motor hall signal cable fault Check the motor module
“09” Motor phase cable fault Check the motor module
“11” Controller temperature sensor failure Check the controller
“12” Current sensor failure Check the controller
“13” Battery temperature fault Check the battery
“21” Speed sensor fault Check installation position of speed sensor
“22” BMS communication fault Replace the battery
“30” Communication fault Check the controller connection
Error display
The motor temperature has
reached the threshold.
Note: Error Code 10 will probably appear on the dispaly when the
e-bike is climbling for a long time. This indicates that the motor
temperature has reached the protection value, in which case the
user needs to stop the e-bike for a rest. If the user continues to run
the e-bike, the motor will automatically cut off the power.
“10”
Stop the bicycle until the error code "10"
disappears from the screen.
USER MANUAL DP C10.UART