13
ELECTRONIC COMPONENTS
CUSTOMER MANUAL
REAR HUB MOTOR SYSTEM
Charger
The charger is specially designed for charging
lithium-ion batteries. It is equipped with an inte-
grated fuse and protection against overcharging.
Keep the charger away from children and
animals. Small children and animals may
damage the cable while playing. This can lead
to an electric shock, a malfunction or a fire.
•
The charger must not be used by children, or
by persons with limited physical, sensory or
mental capabilities, unless under the supervi-
sion of a responsible adult.
•
Make sure the charger is clean. There is a
risk of electric shock.
•
do not use your charger in humid or dusty
places.
•
Avoid direct sunlight.
•
disconnect the charger from the power sup-
ply when not in use.
•
Only use the charger that came with your
pedelec or one from the same manufacturer.
•
don’t cover the charger while it is in use. It
could otherwise short circuit or cause a fire.
•
When you clean the charger, unplug it from
the electrical socket first.
•
When charging takes longer than shown in
the specifications table, stop charging.
•
After charging, remove the battery from the
charger and unplug the charger.
4.4 Hub motor
Your Pedelec is equipped with a 250 Watt
rear-wheel electric motor, which also forms the
hub of the rear wheel.
Motor / Product Model: RM G020.250.dC
Keep in mind that the motor of your Pedelec
can heat up during long uphill runs. do not
touch the motor, as you may get burnt.
The drive is activated as soon as you push down
on the pedal. The degree of support depends
on the settings on the control unit. As soon as
you stop pedaling while driving, or when you
have reached the maximum speed, the drive will
be disabled. The support is automatically
reactivated as soon as the speed is below the
maximum support speed and you reapply
pressure to the pedal.
Note that if the road surface is slippery (e.g. due
to rain, snow, sand), there is a risk that the front
wheel of your Pedelec may spin and slide.