Page 4
For technical questions, please call 1-888-866-5797.
Item 59136
Sa
FE
ty
Op
Era
ti
O
n
Maint
Enanc
E
SE
tup
Setup - Before use:
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
note:
For additional information regarding the parts listed in the following pages,
refer to
Parts List
on page 8.
tool Set up
attaching the Handle
cautiOn! the Handle Socket will be held
down by a plastic block under tension. Wear
anSi-approved safety goggles before freeing
Handle Socket. Hold Handle Socket down while
removing block. after removal, carefully swing
Handle Socket up until tension is released.
1. Fasten the Upper Handle to the Lower Handle.
2. Loosen the Set Screw and insert the
assembled Handle into the Handle Socket.
3. Tighten the Set Screw.
attaching Front & rear Wheels
1. Lift Jack off the ground from the front end.
2. One at a time, place Front Wheel
(17) onto front axle.
3. Secure front end wheel with Bushing (16) and
tighten with Washer (18) and Nut (19).
4. Repeat installation process for
each Rear Wheel (29).
Functions
Handle
Handle
Socket
Saddle
Lift arm
Saddle
Extension
Handle
Lever
Front axle
rear axle
