5.1/0207/TG
Page 4 of 5
STEP 3 - PICTURE 3
:
With the bassinet in its upright position, wrap the FABRIC SKIRT
(I) around the lower rim of the BASSINET BODY (H) pressing
the grip tape strips together as you go around. Begin and end at the
rear center where the metal spindle is located (the ends may overlap).
STEP 4 - PICTURE 4
:
There are two holes in the metal spindle on the bassinet body to
height adjust the canopy. Insert the METAL CANOPY POLE (J)
into the metal spindle on the bassinet body (H) and line up a hole
on the metal spindle with the push button on the canopy pole. Make
sure the push button snaps into the hole.
STEP 5 - PICTURE 5
:
Insert the two free ends of the CANOPY FRAME (K) into the top
of the CANOPY POLE (J). Tap gently with a hammer until the
ends of the frame are fully seated inside the pole.
Place the FABRIC CANOPY (L) onto the CANOPY FRAME (K).
Secure it to the frame with the ribbons and/or the grip tabs.
I
H
PICTURE 3
PICTURE 2B
H
A
A
J
Push button
on canopy
pole (J) must
snap into the
hole on the
metal spindle.
PICTURE 4
PICTURE 5
J
K
F
