5.1/0207/TG
Page 3 of 5
STEP 2
-
PICTURE 2A (this page) and 2B (on page 3):
Using the FOUR L-BRACKETS (F) and the SIXTEEN
SHORT BOLTS (G), bolt the BASSINET BODY (H) to the
BASSINET STAND.
Put the bassinet body upside down, and then put the bassinet
stand upside down on top of the bassinet body as shown in
PICTURE 2B
.
Line up the four pairs of holes on the END PANELS (A)
with the four pairs of holes on the BASSINET BODY (H).
Position the L-BRACKETS (F) on the INSIDE OF THE END
PANELS and secure them using the SIXTEEN SHORT
BOLTS (G).
WARNING !
Once the bassinet stand is
assembled, do not disassemble
and reassemble for future use.
Doing so may affect the
stability and safety.
PICTURE 1B
A
B
A
D
B
PICTURE 1A
STEP 1
-
PICTURES 1A and 1B:
Attach ONE CASTER WHEEL (E) to each leg of the END PANELS (A) using ONE
BOLT (E2) and ONE KNOB (E3) for each WHEEL (E1). The knobs go on the inside. The
square hole on the wheel goes on the outside so the head of the bolt “locks” into the hole.
Take ONE END PANEL (A) and attach the TWO RAILS (B) using TWO LONG BOLTS
(C).
The grooves on the rails face inwards.
The T-Nuts pre-installed on the end panels
face out.
Slide the SHELF (D) into the grooves with the white warning label facing up. Then attach
the second END PANEL (A) to the TWO RAILS (B) using TWO LONG BOLTS (C).
PICTURE 2A
H
A
These assembly instructions cover both Elegance
™
ROUND bassinets and Elite
™
OVAL bassinets.
The shape of the units is different but the parts and
assembly steps are identical.
IMPORTANT!
THE T-NUTS
ON THE END
PANELS ARE
ON THE
OUTSIDE.
THE
BRACKETS
ARE ON THE
INSIDE.
