1.0/0205
STEP 4:
See PICTURE 4.
Attach the CANOPY POLE (J) to the TOP and
BOTTOM BACK RAILS (C, F) using TWO 1¼”
BOLTS (Q), TWO WASHERS (S) and TWO T-NUTS
(R).
The canopy pole has dimples for the bolt heads.
Push the bolts through the pre-drilled holes on the metal
pole and screw into T-NUTS (R) inserted into the holes
on the inside faces of the rails. Fully tighten the bolts so
the pole stays in place.
Note: The T-NUT (R) on the inside of the TOP
Back Rail (F) is installed by our factory. Check to make
sure it did not come loose or fall out in shipping because
the canopy pole will not attach without the T-Nut in
place.
STEP 5:
See PICTURES 5A AND 5B.
As shown in PICTURE 5A, if the WHEELS (L)
are not already installed, insert them into the holes on
the ends of the legs (B).
Then, as shown in PICTURE 5B, grasp the leg
sand push down pressing the wheels firmly against the
floor so they snap into place.
STEP 6:
See PICTURE 6.
Attach the SKIRT (N) to the BUMPER/LINER
(E) by pressing the grip tape on the skirt to the tape on
the liner. Start at the middle front, work your way around,
and return to the middle front. Tie the front ribbons into
a bow.
Put the SHEET (O) onto the MATTRESS PAD
(M) and put the pad into the bassinet. Tuck the end flap
of the sheet securely under the pad.
STEP 7:
See PICTURE 7.
Insert the free ends of the CANOPY FRAME
(K) into the top of the CANOPY POLE (J). Tap into
place with a hammer.
Place the FABRIC CANOPY (P) over the
CANOPY FRAME (K) and tie the canopy to the frame
using the ribbons.
STEP 8:
See PICTURE 8.
The bassinet is now assembled and ready for your
baby!
Additional sheets are sold separately in a pack-
age of two (Model #00027). Check our web site at
www.badgerbasket.com!
Page 3 of 4
PICTURE 3B -
Outside View
E
C and D
R
PICTURE 4
J
E
C
F
PICTURE 5A
PICTURE 5B
