Bad Boy CZT 6000 Elite Series, Owner'S, Service & Parts Manual

Page: 18 / 52

After filling the transaxles with fresh oil, lift rear of mower until its rear tires are off the ground; then chock the front
caster tires. Start the engine and release the parking brake. Next, with the bypass valves open, slowly move the drive
arms forward and rearward. Keep away from the rear tires: they will be rotating and present a safety hazard. After
the drive arms have been pushed forward and rearward five times, turn the engine off and close the transaxle bypass
valves. Check the oil level in each hydro reservoir after the first 15 minutes of subsequent usage; it may be necessary
to add more oil to the reservoirs.
SECTION 2: DRIVE BELT
Shown on the right is a typical pump belt tensioner for
your model mower.
Tightening the two ¾˝ jam nuts on the right side will
increase the belt tension on all models. Factory setting is
about .030˝ (about the thickness of a credit card) between
coils as shown.
PAGE 18