SKU 272-0095/FC-30-MN
08
© 2018 Jack-Post Corporation 09/18
SEAT
STEP 1
Select four 10" x 2" x 4" cleats. Locate and drill two 1/4" diameter holes in each cleat, as shown.
Counterbore each of the holes with a 5/8" bit to a depth of approximately 1/8". This will allow clearance for the carriage bolts in STEP 4.
1 1/2"
5/8"
1/8"
1/4"
4"
10"
WHEN INSTALLING
ASSEMBLED SEAT
THIS EDGE OF CLEAT
FACES TABLE TOP
STEP 2
Layout the three seat boards when using 2" x 4"
’
s (or) two boards when using 2" x 6"
’
s), best side down on a flatsurface,
maintaining a 1/4" spacing between boards. Measure and mark the following distance from both ends as follows:
8
'
SEAT – 10" FROM END
6
'
SEAT – 6" FROM END
4
'
SEAT – 4" FROM END
DRAW ONE LINE
AT BOTH ENDS OF TABLE
MAINTAIN 1/4" SPACE
BETWEEN ALL BOARDS
STEP 3
Insert two 3-1/4" carriage bolts into counterbored holes in cleat.
STEP 4
Nail cleat to seat boards,
“
trapping
”
head of carriage bolt between cleat and seat boards,
as shown. Be certain to coat mating surface with glue.
WOODEN CLEAT
SEAT
NAIL
3-1/4" CARRIAGE BOLT
GLUE
3-1/4" CARRIAGE BOLT
WOODEN CLEAT
3-1/4" CARRIAGE BOLT
POSITION EDGE OF CLEAT ON MARKED LINE
NAILS
WOODEN CLEAT
MARKED LINE
STEP 5
Repeat STEPS 2 - 4 at other end of seat boards.
4"
14 3/4" 14
3/4" 4"
6"
15"
16"
15"
6"
10"
21"
20"
21"
10"
FOR 8
'
TABLE
FOR 6
'
TABLE
FOR 4
'
TABLE
STEP 6
Locate the remaining cleats as shown below.
STEP 7
Repeat STEPS 1 - 6 for second bench.
