INSTALLATION
INSTALLING THE CAMERA
1.
The rear view CMOS camera uses a 170° wide-angle lens for best all around
performance. The Camera will display the full width of most parking spaces up to 7 feet
or even wider.
2.
The camera is designed to be flush mounted on vehicle’s surface. It can be mounted
anywhere on the vehicle that has a flat surface. Double check behind the surface of
where you will be mounting the camera to make sure that there is adequate space for the
camera to be placed in the decided location.
3.
Use the provided Hole Saw bit to drill the hole in the location you have chosen for
mounting the camera.
(See FIGURE 5)
WARNING
: When drilling the hole, be careful not to use excessive force when pushing
on the drill as the bit may break through the surface quickly and puncture
anything behind it resulting in damage to any modules or OEM parts behind
the mounting location.
4.
Once the hole has been drilled, route the RCA and Power cables through the hole and
snap the camera into place. The steel lock tabs will hold the camera tight to the mounting
surface.
(See FIGURE 5)
Mounting Clip
Use the Provided Hole Saw
Bit to Drill the Hole for the Camera
Camera
Lens
Cable
Mounting
Surface
Summary of Contents for CA-5030
Page 16: ......
