BACKSAFE STUGO 16810010, Instruction Manual

Page: 3 / 9

2
Specifications
Model 16810011 16810012
Rated lifting capacity 1000kg
Max. fork height 800mm
Min. fork height 85 ±2 mm
Fork length 1140mm
Fork width (outside) 520mm 680mm
Fork width (inside) 196mm 356mm
Lifting speed
9mm / stroke
Descending speed
∠
0.1 mm/second
Net weight 105kg 112kg
Safety Instructions
1. The truck shall be used in accordance with instructions handbook.
2. Don’t put the hand & foot under the fork at any time.
3. Don’t work on the slope surface.
4. Quick lifting is prohibited for loads of more than 300kg. Any manipulation of the pressure relief valve is
strictly prohibited. All assembling, adjusting and maintenance shall only be done by industrial mechanics
trained people. These people must be familiar with all safety regulations of European and nationally
where the item is in use relating to the operation and maintenance of pedestrian controlled industrial
trucks.
5. Load should be put on the fork center. Side-load is strictly prohibited.
6. The truck shall not be used to transport persons.
7. It is recommended to the driver to wear security shoes.
8. No modifications shall be carried out which adversely affect the compliance of the truck with prEN 1757-4.
Installation & Adjustment
1. Screw (part No.158)

To prevent oil-leaking from oil tank during transportation, Air Screw (part No.158) is replaced with
Oil-sealing Screw in the factory. But it has to be replaced back when you put this truck in use.

How to change: Screw out Oil-sealing Screw, then screw in Air Screw with which the Pump housing
(No.160) is hung, thus keep oil tank always connecting with atmosphere.
2. Handle
During transportation, the handle is disassembled from the truck and packed separately. It has to be
assembled back and adjusted properly and carefully before use.
a) Handle installation :
 Take 3 pieces of M10 Nut (No.185) & spring washer from spare parts bag. Select handle to match
the truck with the same fitting numbers.

Assemble the handle on the Handle Base (No.181) with 3 pieces of M10 Nut & Spring Washer
tightly.

Put the chain’s Eye Bolt (No.110) in the slot at the front end of Pendulum Arm (No.112).
0 1