Back View RV-250, User Manual

Page: 46 / 168

46
◆
Switch on the ignition and the monitor via the on-/off-
switch POWER to ON (see
✎
I 1).
◆
Adjust the brightness or the contrast to your needs.
◆
If you have connected the cable set of the monitor completely, then the
brightness of the picture must be reduced automatically when switching
on the light.
◆
Switch off the monitor via the ON/OFF-button.
◆
With switched on ignition the monitor must switch on as soon as
the reverse gear is put in.
◆
If you pull the reverse gear out, then the system switches
back to stand-by.
On the back of the monitor is the reversing switch (blue
dip switch) for the normal/inverted representation on the monitor. In
the inverted representation you can see the image on the monitor just like
if you were looking into the rear mirror of your vehicle.
Dip switch MIRROR in the bottom position = inverted representation
Dip switch MIRROR in the above position = normal representation
Adjustment and operational check
Adjustment of the camera
◆
Switch on the monitor and the camera as described beforehand.
◆
The monitor screen should show at the lower margin the rear or the
bumper of your vehicle (see
✎
J 1). The centre of the bumper
should be also located in the centre of the monitor screen. The correct
adjustment can be achieved by twisting the camera in the camera-
holder (see
✎
J 2).
◆
If you have adjusted the camera correctly, tighten the 6 screws of the
camera fixing.
Attention! The plug connection at the camera is not protected
against humidity. It is absolutely necessary to seal the connection
with seal strip in order to avoid a damage.
HINT: In order to minimize corrosion in the plug, we recommend
to put some grease, e.g. pole fat into one of the plugs.
In order to minimize the corrosion of the screws, it is
recommendable to grease the threads.
A5_921-02 -GB- RV 250 neu.p65 18-09-2003, 11:30 46