Bachmann Europe Plc
10
H0 1:87
Changing the motor
First remove the top circuit board as shown
in
Fig. 9, it is fitted with two screws to the
interior. You can now gently remove the
plugs (
M2). In order to be able to remove
the bogie from below, loosen the two
screws (
M3) and remove the retaining lid
(
M4). You can now unclip the motor bracket
(
M5) on the individual bogies and removed
the motor (
M6). Refitting is effected by fol-
lowing the sequence in reverse.
If you have decided on a LILIPUT model for
the three rail AC system, please observe the
following:
This model has a digital decoder installed
(ESU Lokpilot) which can be used to power
your vehicle either on an analogue basis
(16 Volt AC) or digitally. Please consult the
instruction sheet supplied by ESU for details
on how the decoder works. For power pick
up from the central rail, the slider has to be
clipped on to the bogie with the aid of a
holder (
AC1) as shown in Fig. 10. To change
the slider, please slightly press apart the
retaining arms (
AC2) of the holder using a
small screwdriver. This enables the retaining
seat of the central slider to be removed from
the holder
R.
M1
M3
M2
M5
M6
M2
M4
Fig. 9
Your model as an AC variant
Fig. 10
AC1
AC2
LILIPUT hopes that your railcar model will give you a lot of pleasure.
R
