Portable Monitor Bladder Bag Replacement
4
Instruction 3015-5545 Rev 1
5.
To place bladder bag in position, fold bag in half lengthwise and insert the folded edge into the corner of the rear panel.
Hold seam in corner and open the fold to contact the adhesive side of the two Velcro pieces. Press bag firmly into place.
Figure 5 – Bladder Bag Placement
6.
Take tubing removed in Step 1 and trim approximately ¼ inch off the stretched end of the tubing where it was connected to
the T-fitting.
7.
Secure the tubing separated in step 1 by reinserting it over the T-fitting first and then over the valve opening.
8.
Reassemble the chassis.
9.
Perform a function check by running the “Fill Bag” and “Empty Bag” cycles several times to ensure proper operation.
∇
∇
∇
Headquarters:
621 Hunt Valley Circle, New Kensington, PA 15068
Tel: +1-724-334-5000 • Fax: +1-724-334-5001 • Toll Free: 1-800-736-4666
Website: www.MyBacharach.com • E-mail: [email protected]
Printed in U.S.A.
® Registered Trademark of Bacharach Inc.