1100-2290
Revision 0
6
MGS-410 Quick Start Guide
STEP 1 | Mount Gas Detector & Remove Lid
WARNING:
DO NOT allow the lid / sensor to hang from the ribbon cable.
Failure to comply may result in damage to the product.
IMPORTANT:
The manufacturer of this product requires that a bump test or
calibration be performed following installation to verify instrument functionality.
5. Installation
1. Mount the MGS-450 according to the product dimensions, maximum wiring
lengths and following considerations:
•
Environment:
the full range of environmental conditions when selecting a
location
.
•
Application:
the specifics of the application
(possible leaks, air movement / draft,
etc.)
when selecting a location
.
•
Accessibility:
the degree of accessibility required for maintenance purposes
when selecting a location
.
•
Target Gas:
the specific gravity of the target gas when selecting the height of
the instrument
.
2. Using a 5/32″ (4 mm) hex key / allen wrench (not included) remove the lid and
disconnect the ribbon cable from the base.
3. Set the lid and rubber gasket (IP66 version only) aside to be reinstalled later
