IEQ Chek
Operation Manual
16
1509-9001 Rev 1
After the sampling rate has been selected, the logger START method must be
selected from one of the following.
STARTUP:
Logging will start when the IEQ Chek™ is turned on and
ACTIVATE has been selected from the DATALOG menu
SET TIME:
User can set the time and date to start logging
After the START method has been selected the END method must be selected from
one of the following.
FILE FULL
: Logging will stop when the flash card memory is full
FIXED
:
User selects how many samples to take before logging is
stopped.
SET TIME
: User can set the time and date to stop logging.
After the END method has been selected, the logging location can be selected. The
selections available in the LOC (location) menu are:
NONE
SETUP
<EMPTY>
<EMPTY>
<EMPTY>
<EMPTY>
<EMPTY>
<EMPTY>
Choosing NONE will not set a location for logging. The user can customize this
location list as described under the
LOCATION
option on page 16.
ACTIVATE:
This menu item allows the user to enable the data log (information
recording) session. Press the MENU button with this item selected and the LCD
indicates
DATA LOG HAS BEEN ENABLED
.
NOTE:
Once the data logger has been set up, it will not start until
“ACTIVATE” has been selected from
the DATALOG menu.
NOTE:
If the user experiences an error message
MEMORY CARD
CORRUPT
,
the flash card must be formatted. Reference information below
under “FORMAT”.
NOTE:
If memory card is not installed before “ACTIVATE” is selected, the
user will experience an error message
PLEASE INSTALL MEMORY CARD
.
The display will then flip back to the data log menu.
STOP LOG:
This menu item allows the user to turn off the data log session. Press the
MENU button at this item and the LCD indicates
DATA LOG HAS BEEN STOPPED
.
LOCATION:
This menu item allows the user to enter names or identifiers
(alpha/numeric) for up to six locations for logging purposes. Names are limited to
eight characters. An example is shown below.
