Instruction 19-9326
8
Monoxor III
3.4 Setup Mode
The analyzer s preset at the factory for the parameters shown below, but
can be changed as descrbed n ther assocated sectons.
Function
Parameter
To Change
Temperature Unt
°F
Secton 3.4.2
CO Channel
Auto Zero
Secton 3.4.3
Tme
Not Set
Secton 3.4.4
Date
Not Set
Secton 3.4.5
Year
Not Set
Secton 3.4.6
Prnter
IrDA
Secton 3.4.7
3.4.1 Entering Setup
1. Wth the analyzer turned OFF, press and hold down the
HOLD
button.
2. Press and release the
I/O
button.
3. Release the
HOLD
button.
4. The analyzer s now n ts Setup Mode. Refer to Sectons 3.4.2 thru
3.4.7 for nformaton on how to set the analyzer’s varous parameters.
3.4.2 Temperature Units Setup
The Temperature Unts Setup Screen s labeled “Unt”.
Note:
The analyzer uses an internal temperature sensor
to maintain CO sensor accuracy under varying ambient
temperature conditions. This sensor’s temperature reading is
displayed
only during calibration
as described in Sec-
tion 5.2.
Summary of Contents for 19-8104
