7
8
ASSEMBLY
ASSEMBLY
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
• Line up the front fender and press onto
the front frame assembly (Fig. 5c).
• Insert the 5 screws through the
underside of the front frame assembly
into the front fender’s plastic tubes.
Tighten the screws only until snug
(Fig. 5d).
DO NOT OVER TIGHTEN.
REAR WHEEL
6)
• Lean the stroller forward to rest on the
front wheel. To attach the rear wheels,
push each wheel’s axle into the plastic
corner fitting (Fig. 6). Depress the metal
lever on the inside of the corner fitting
as you push the axle into corner fitting.
When the wheel will not go on any
farther, release the lever.
NOTE:
Check that the wheel has locked
into the corner fitting by pulling on the
wheel. If not locked, lift upward on the
lever, push the wheel on farther and
release lever.
• Ensure that the wheels are firmly
locked into place.
NEVER
use the
stroller if the wheels are not locked into
place, contact our customer service
department immediately at 1-800- 328-
7363, between the hours of 8:00am and
4:30pm PST, for assistance.
Fig. 6
PARENT TRAY
WARNING:
Do not
place hot liquids or more
than 3 pounds in the parent
tray. Serious burns or
unstable conditions could
result.
7)
• To attach the parent tray, position the
parent tray in the center of the stroller
handle.
• Snap the upper portion of the tray over
the handle (Fig. 7a).
• Attach the lower portion of the parent
tray to the cross tube, with the screws
provided (Fig. 7b).
CANOPY
8)
•
To open the canopy:
push forward
on the front edge of the canopy. Push
downward on the tensioners to secure
(Fig. 8).
Fig. 5c
Fig. 5d
Fig. 7a
Snap
Fig. 7b
Insert screws
Fig. 8
Open
