53
54
7.0
INSTALLATION
7.0
INSTALLATION
1. Remove any toy or other objects
attached to carry handle before
installing car seat in vehicle.
2. Locate a
UAS
seating position as
identified in your vehicle owner’s
manual. Some
UAS
seating positions
may require deploying of anchors, or
installation of guides.
3. Remove the Safety Seat from the
base by squeezing the base release
handle located under the center of
the head end of the Safety Seat and
lifting upward on the Safety Seat
(Fig. 24-1).
4. Remove the
UAS
connectors from
their storage position inside the base
(Fig. 54-1). Place the Base in the
rear-facing position in a forward
facing vehicle seat as shown in
(Fig. 55-1).
The Child must face the
rear of the vehicle and Safety Seat
must be placed in a vehicle seat that
faces forward.
Fig. 54-1
Fig. 54-2
UAS Anchor
5. Locate the
UAS
anchors in the
vehicle seat (Fig. 54-2). Once
located, snap the Safety Seat
UAS
connectors onto the steel rod. Listen
for the click and check that both
connectors are firmly attached to the
anchor rods by pulling outward on the
connectors (Fig. 55-2).
6. Proper installation of the Base
requires that the
UAS
webbing be
very tight. To tighten the webbing,
push down hard with your knee
or hand on the Base while pulling
upward on each webbing end. The
webbing will automatically lock in
place.
Check that there is no slack in
the webbing on both sides of the base
and that the base is tightly installed
(Fig. 55-2 and 55-3).