CAR SEAT OPTIONS
FOLDING THE CHASSIS WITH THE SEAT UNIT FITTED
The Oyster can be fitted with several car seats. Always check with
your retailer that you have the correct car seat adaptors (if required).
The Oyster can be folded with the seat unit fitted facing either
forwards or backwards.
To fold the chassis with the seat unit facing forwards: Remove the
bumper bar. Pull the backrest seat recline lever and fold the backrest
forward so that it lies completely flat on the seat base. If the seat
back rest stops before it is completely flat, lift the backrest seat recline
lever a little more, and lower the seat back rest. The chassis can now
be folded with as described above in “FOLDING THE CHASSIS”
OYSTER car seat, requires LB321 adaptors
MAXI-COSI CabrioFix requires Oyster Maxi-Cosi car seat adaptors
BRITAX Baby-Safe SHR does not require adaptors
To fold the chassis with the seat unit facing backwards: Remove the
bumper bar. Pull the backrest seat recline lever and fold the backrest
so that it lies completely flat on the seat base. If the seat back rest
stops before it is completely flat, lift the backrest seat recline lever a
little more, and lower the seat back rest. The chassis can now be
folded with as described above in “FOLDING THE CHASSIS”
FITTING THE Maxi- Cosi CabrioFix CAR SEAT TO THE OYSTER
CHASSIS
The car seat can not be attached to the chassis until the seat unit or
the carrycot has been removed.
Insert the car seat adaptors into the Oyster chassis attachment
device, the adaptors are marked “1” and “2”, 1 is right and 2 is left.
Push down on the adaptors until they click and lock into position.
Hold the car seat by the carry handle and lower the car seat onto the
car seat adaptors, the adaptors should slot into the cavity at the base
of the car seat handle left and right. Push the car seat down firmly
until the car seat clicks and locks into position. Check that the car
seat is secure and locked by pulling up on the car seat handle.
The most compact fold is with the seat unit removed.
ADJUSTING THE SEAT UNIT BACKREST
10
7
REMOVING THE Maxi- Cosi CabrioFix CAR SEAT FROM THE
OYSTER CHASSIS
To recline the seat unit: With your fingers hold the lever at the top
back of the seat unit and lift the lever. While holding the lever,
reposition the backrest to the required position. The seat backrest
has three positions; upright, intermediate and reclined. When the seat
backrest is in the required position, release the lever and the seat will
lock into position.
To remove the car seat from the chassis: Press down on the two
buttons on the sides of the car seat (not the handle adjustment
buttons where the handle turns) and lift the car seat away from the
chassis.
To remove the adaptors from the OYSTER chassis pull up on the
recessed handles and lift the adaptors away from the attachment
device.
FITTING THE Britax Baby-Safe SHR TO THE OYSTER CHASSIS
The car seat can not be attached to the chassis until the seat unit or
the carrycot has been removed. The Britax Baby Safe SHR does not
require adaptors to fit onto the OYSTER chassis. Hold the car seat by
the carry handle and lower the car seat onto the chassis so that the
fittings below the car seat handle slide into the attachment device on
the OYSTER chassis. Push the car seat down firmly until the car seat
