background image

04

3.  TO USE THE SWIVEL WHEELS

A. 

Lift the locking clip up to lock the swivel wheels. The 
swivel wheels can only be locked when the wheels are 
in the trailing position (wheels under frame).

B. 

Push the locking clip down to allow the wheels to 
swivel.

NOTE: Always lock the swivel wheels when using the stroller 
on rough surfaces it will minimise wheel wobble. 

4.  TO USE THE BRAKES

WARNING:  Always apply the brakes when parking the stroller.  
The stroller may roll away even if left unattended for a few 
moments.

A. 

Push down on each brake lever to lock the brakes.

B. 

Lift each brake lever up to release the brakes.

5.  TO SECURE YOUR CHILD IN THE HARNESS

WARNING:  Use this harness at all times.

A five-point harness is provided to restrain your child. To
secure the child in the harness, push buckle (A) and (B) into 
the buckle housing (C) until the buckle prongs snap into 
position. Carefully adjust the harness by pulling the slider (D) 
until the desired fit is achieved in the lap, shoulder and crotch 
straps. Always adjust the harness when changing the seating 
position of the child. To release the buckle, squeeze the top 
and bottom prongs.

www.babylove.com.au

A

B

B

A

09

www.babylove.com.au

HELPFUL HINTS

If the wheels squeak - use a silicon based spray or light oil ensuring it penetrates the 
wheel and axle assembly. 

When using your stroller at the beach - completely clean your stroller afterwards to 
remove the sand and salt from the mechanisms and wheel assembly. 

If there are compression marks on the tyres - use a domestic hair dryer to gently warm the 
tyre and the compression marks should slowly disappear. (DO NOT OVERHEAT).

DO NOT DRY CLEAN, OR USE BLEACH.

Do not machine wash, tumble or spin dry, unless the care labelling on the product 
permits these methods.

Non removable fabric covers and trims may be cleaned using a damp sponge with soap 
or mild detergent. Allow it to dry completely before folding or storing it away.

In some climates the covers and trims may be affected by mould and mildew. To help 
prevent this occurring, do not fold or store the product if it is damp or wet.  Always store 
the product in a well ventilated area. 

Always check parts regularly for tightness of screws, nuts and other fasteners - tighten if 
required. To maintain the safety of your nursery product, seek prompt repairs for bent, 
torn, worn or broken parts. Use only those parts and accessories approved by Britax. 

THIS PRODUCT IS NOT INTENDED FOR COMMERCIAL USE.

Summary of Contents for maxima







Reviews: