50
51
Front of Vehicle
IF THE CAR IS NOT FITTED WITH
CHILD RESTRAINT ANCHORAGE
POINTS
For Sedans only
- Drill 9mm diameter
hole in the parcel shelf on the centre
line of the seating position as shown in
Fig.3. Before drilling the hole, check the
underside for accessibility. Install the
anchor bolt as shown in Fig.2.
For vehicles other than Sedans
- In
Australia, consult your nearest child
restraint fitting station or traffic authority
for vehicle inspection to find the best,
correct position for the placement of
the anchorage point, and for the correct
attachment bolt length and use of
spacers. In New Zealand, consult the
agent for the vehicle.
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle metal
structure
Reinforcing
washer (cone
downwards)
Lock washer
Secure nut
UPPER ANCHORAGE
FITTINGS FOR SEDANS ONLY
Vehicle trim
Fig.2.
INSTALLATION OF CAR ANCHOR FITTING
INSTALLATION OF CAR ANCHOR FITTING
Note: Marking on
the top of a Grade 5
Bolt.
Note to Queensland purchasers: The installation of anchorage points must be
approved by authorised officers appointed by Queensland Transport. Authorised
officers can be sourced from all Queensland Transport Customer Service and
Queensland Ambulance Service Centres.
ONLY USE A 5/16 UNC GRADE 5 BOLT. IF THE
BOLT IS NOT THE CORRECT LENGTH THE
CAR MANUFACTURER’S HAND BOOK CAN
PROVIDE ADVICE ON THE CORRECT LENGTH
BOLT.
Front of Vehicle
Centre line of
seating position
Fig.3.
200mm
min.
CHILD RESTRAINTS MUST NOT BE
ATTACHED TO UNSOUND METAL OR TO
WOOD, OR SYNTHETIC STRUCTURES.
WHEN DRILLING 9 MM HOLE DO NOT
DRILL THROUGH FUEL LINES, FUEL
TANKS, ELECTRICAL WIRING, OR RADIO
SPEAKERS.
WEBBING STRAPS MUST BE
PROTECTED FROM SHARP CORNERS
AND EDGES. THE ANCHOR FITTING
MUST BE USED ONLY AS DESCRIBED
ABOVE. IT MUST NOT BE HOOKED ONTO
ANY OTHER OBJECT.
Summary of Contents for BL620A 2010
Page 28: ...54 55 NOTES NOTES ...
