B79FSGA/B79FSMBA
PROFESSIONAL ALL-METAL
INTERCHANGEABLE SHAVER
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances,
especially when children are present, basic
safety precautions are required to always
be followed, including the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
SAFETY CAUTIONS
• For the purposes of recharging the
battery, only use the adapter provided
with this appliance.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety.
• Keep oil out of reach of children.
• Children should be supervised to ensure
that they do not play with the appliance.
• The battery is not replaceable.
• This appliance contains batteries that are
only replaceable by skilled persons.
• Store out of children’s reach.
• If the supply cord is damaged, it must be
replaced by a special cord or assembly
available from the manufacturer or its
service agent.
OPERATING INSTRUCTIONS
Before using the battery powered shaver
for the first time, charge the battery
continuously for 3 hours. Maximum
battery capacity will only be reached after
3 charging and discharging cycles. A full
charge will provide 4 hours of use.
ON/OFF SWITCH
To operate shaver, simply slide switch to
the ON (“I”) position. To stop operation,
slide switch to the OFF (“0”) position. Make
sure the switch is in the OFF (“0”) position
when the shaver is not being used.
•
Return the appliance to the nearest
service facility for examination, electrical
or mechanical adjustment or repair.
• The appliance must only be supplied at
safety extra-low voltage corresponding
to the marking on the appliance.
• Do not immerse into water
or other liquids. Do not
use near basins or other
vessels containing water.
• For additional protection, the installation
of residual current device (RCD) with a
rated operating current not exceeding
30mA is available in the electrical
circuit supplying the bathroom. Ask your
installer for advice.
•
Do not use the appliance if it has
been dropped or if it shows noticeable
damage.
• Do not leave unattended when switched
on and always allow to cool before
storing away.
• Do not use any attachments other than
those recommended by BaBylissPRO.
• Do not use this appliance with damaged
or broken foils, as injury may occur.
• The appliance is intended for commercial
use.
• If the appliance is to be stored unused
for a long period, the battery should be
removed.
•
It is a battery-operated appliance,
the battery being charged outside the
appliance.
• The supply terminals are not to be short-
circuited.
WARNING: Keep the appliance dry
2
3
VERY IMPORTANT: Cutters must
be cleaned on a regular basis
for proper functioning. Failure to
regularly clean the cutters will void
the warranty.
BASIC INSTRUCTIONS FOR USE
1. Men whose skin is sensitive or easily
irritated by shaving, or who suffer from
a skin allergy, should test the shaver
on one section of the leg or arm before
using it.
2.
Remove the magnetic cap and turn
on the unit to start shaving. Hold the
shaver at a right angle to the area that
you want to shave and run the double
shaving foil carefully along your skin.
Tip: In general, we recommend that
you shave against the direction of hair
growth, as this is the best way to trim
the hair. Pull your skin tight with your
fingers in inaccessible areas to achieve
optimum results.
3. Switch the shaver off each time after
shaving and clean it.
4. Do not push the shaver on the skin
too hard, as this could cause irritation,
make the shaver warm and prevent a
perfect shave.
5. Please note that it takes 2 to 4 weeks
for your skin to adapt to a shaver, so do
not change shaving instruments during
this period of time.
6. If hair is longer than
1
/
32
", begin by
cutting the hair down first with a
trimmer, then use shaver for a smooth,
close shave.
7. This shaver is equipped with a foil head
that pivots from side to side to help the
shaver head perform consistently over
uneven skin surfaces. The pivoting head
can be locked to prevent it from pivoting
if desired. To lock the pivoting foil head,
simply move the locking switch on the
back of the shaver handle to the lock
position. To unlock, move the locking
switch back to the unlock position.
NEW
Pivoting Foil Head
with Locking Feature
Locking Switch
B79FSG(MB)A IB-23_450.indd 2
B79FSG(MB)A IB-23_450.indd 2
2024/1/8 15:00
2024/1/8 15:00
