Comb Guides
• To attach a comb guide, ensure the appliance is switched off. Position the comb
guide over the front of the clipper blade and slide over the head. Push and click
the rear of the comb guide into position (see Fig.1).
• To remove the comb guide, ensure the appliance is switched off. Pull the tab on
the rear of the comb guide away from the head and lift off (see Fig.2).
Taper Control
The taper control lever enables fine cut adjustment for precision clipping.
• To increase the cutting length, push the lever down.
• To reduce the cutting length, push the lever up.
Preparation for Use
• Always inspect the appliance before use to ensure the clipper blades are free
from hair, debris etc.
• For best performance, use on clean, dry hair that has been combed until tangle-free.
• Ensure the appliance is sufficiently charged or plugged into the mains.
NOTE:
The appliance should not be used for longer than 20 minutes when
operated from the mains.
Attach comb guide
Fig.1
Remove comb guide
Fig.2
Preserving the battery
In order to maintain the optimum capacity of the rechargeable battery, the
appliance has to be fully discharged every 6 months approximately. Then recharge
the appliance to full capacity, again for 3 hours.
Oiling Instructions
IMPORTANT!
It is highly recommended before each use to oil the blades with
the oil provided. This ensures optimum cutting performance. This product is for
commercial use.
For the first use you will need to use the oil supplied with the product, unscrew the
cap and cut off the very end of the plastic tube with a pair of scissors to release
the oil.
To oil the blades ensure the unit is switched on. Gently squeeze the oil tube and
apply 2 drops of oil onto the blades. Leave the unit on for a further few seconds to
allow the oil to thoroughly spread the length of the blades. Switch off the unit and
remove any excess oil by gently dabbing with a cloth.
Oil these 2 positions
Oil these 2 positions
FX673NS IB-17801.indd 9-10
FX673NS IB-17801.indd 9-10
2022/9/15 5:27 PM
2022/9/15 5:27 PM
