HOW TO USE YOUR WAVING WAND
CAUTION!
Do not place the appliance on any heat sensitive surface whilst
in operation. Use the heat mat provided to protect the work surface whilst
styling your hair.
•
Press and hold the button marked ‘I/0’ to switch the styler on. The
temperature display panel will begin to flash 160°C.
•
The styler will automatically adjust to the 160°C temperature setting
each time it is switched on and this will be displayed on the LCD screen.
IMPORTANT:
Within 4 seconds of turning the styler on, the temperature
setting will automatically lock. You are able to adjust the temperature setting
immediately after switching on the styler, however if the temperature locks,
hold down either the ‘+/-’ buttons for 1-2 seconds to change the temperature.
•
The temperature increases in 5°C increments for specific temperature control
(160°C-210°C)
NOTE:
Always start with a lower temperature setting and increase gradually
if required.
•
The temperature on the display will flash while the styler is heating up to
the selected temperature. You may still change the temperature setting at
this time.
•
When the selected temperature has been reached, the temperature display
will stop flashing.
WARNING!
This appliance reaches up to 210°C, please take care to avoid the
hot surface of the barrel coming in to direct contact with the skin, in particular
the ears, eyes, face and neck.
•
Ensure hair is dry and combed through. Divide into sections.
•
Before styling make sure the heat protection glove is worn on the hand which
is wrapping the hair around the barrel.
•
Take a section of hair starting around 2 inches from the scalp.
•
Hold the styler at a slight angle pointing the cool tip downwards.
•
Wrap the hair around and down the barrel until you reach the ends of the
section. As you wrap the hair, ensure it is distributed evenly so the entire
section is touching the barrel. Try not to overlap the hair as you wrap.
•
Hold the end of the hair in place for 3-5 seconds depending on your hair type,
then let go of the end of the hair section and pull the styler away.
•
Repeat as necessary through the remaining sections. Use the heat protection
mat to place your styler on between each section to protect surfaces.
•
Only once hair is cool, run your fingers through the hair to break up the
waves.
•
After use, press and hold the ‘I/0’ button for 1-2 seconds to switch your styler
off and unplug.
•
Allow to cool completely before storing away. For extra protection, wrap the
styler in the salon heat wrap.
HEAT PROTECTION GLOVE
IMPORTANT:
A heat protection glove has been supplied to help protect the
hand from temporary contact with the barrel when wrapping the hair around
the appliance. Please note the heat protection glove is only designed to give
initial contact protection. Discomfort will be caused with prolonged contact
with the hot surface.
STYLING ADVICE
