OPERATING INSTRUCTIONS
1. Before using the clipper for the first time, charge continuously for 3 hours.
Maximum battery capacity will only be reached after 3 charging and
discharging cycles.
2. Make sure the switch on the clipper is in the OFF position. Connect the charging jack
into the receptacle on the bottom of the clipper. Plug the adapter into any electrical
outlet (at the voltage listed on the label affixed to the adapter). The charging indicator
will light up blue to indicate that the charging has begun. Charging is complete after
3 hours.
3. The adapter may become warm while charging. This is normal.
4.
Preserving the batteries: In order to maintain the optimum capacity of the
rechargeable batteries, the clipper should be recharged for 3 hours approximately
every 6 months.
5. Make sure the switch is in the OFF position when the clipper is not operating.
6. If the charging light starts to flash rapidly (more than 4 flashes per second) then the
appliance is faulty. If this happens then please stop charging and remove the adapter
from the mains and contact an authorized Service Center.
FOR DIRECT PLUG-IN OPERATION
Make sure clipper is off. Connect charging jack into the receptacle at the end of clipper
and plug the adapter into power outlet.
ON/OFF SWITCH
To operate, simply slide switch to ON (marked “”). To stop operation, set to the OFF
(marked “ ”) position.
VERY IMPORTANT: Blades must be cleaned and oiled on a regular basis for
proper functioning. Failure to regularly clean and oil the blades will void the
warranty.
USER MAINTENANCE INSTRUCTIONS
MAINTENANCE OF THE BLADE
Always apply oil to the blades before and after use. This will ensure maximum cutting
performance and proper maintenance. Hold the clipper away from your body in a
downward position, and apply a drop of BabylissPro lubricating oil on the front and
sides of the cutter blade. Wipe off excess oil with a soft, dry cloth.
Do not pull, twist, or wrap the supply cord around the appliance.
HOW TO USE COMB ATTACHMENTS
To use the comb attachments, turn the clipper to “ ” position. Slide the
comb attachment onto the top of the clipper blade, and then pull down and
over the back of the blade. To remove, pull up on the back of the comb
attachment and then pull away from the blade.
B870GDBR_B870RDBR_B870WDBR IB-18_367B.indd 5-6
19/07/2019 16:19
