around the barrel until you reach the root. Release the rotate button
and then hold the brush in the hair for a few seconds.
• Repeat as necessary.
• After use, switch off and unplug the appliance.
• Allow to cool before storing away.
• Place protective shield over brush head to protect the bristles. Please
see the ‘Protective Cover’ section for direction
Heat Settings
If you have delicate, fine, bleached or coloured hair, use the lower heat
settings. For thicker hair, use the higher heat settings. It is suggested to
always complete a test on initial use to ensure the correct temperature
is used on the hair type. Start on the lowest setting and increase the
temperature until desired result is achieved.
There are 2 heats plus a cool setting. Slide the ‘on/off’ switch to the
first position to select the cool setting ‘*’, the second position for the
low heat ‘I’, and the third position for the high heat ‘II’.
Rotation Settings
To make the brush head rotate, press and hold the buttons marked
<< and >>, this will make the brush head rotate clockwise and anti-
clockwise.
NOTE:
When the appliance is used on the cool setting, the brush head
will not rotate.
Protective Cover
After every use, always ensure the protective cover is placed over the
brush head. This protects the bristles from damage. When placing
the protective cover over the brush head, ensure to line it up with the
grooves around the top of the airstyler so it slides easily into place.
NOTE:
The diagram on the protective cover demonstrates the direction
it should be placed on to the brush head. If placed on incorrectly it
may be difficult to remove.