Step 4. Replace the fixed blade using the screws and lightly tighten them. Adjust
the teeth as shown in Fig. C, to a gap of 1/32" (0.8 mm) to 1/16" (1.6 mm)
and the small moving blade as centered and parallel as possible to the fixed
blades teeth.
IMPORTANT NOTE:
The top edge of the fixed blade must be a minimum of 1/32"(0.8 mm) higher than the
top edge of the moving blade as centered as possible. This is important so that the
moving blade does not come in contact with the skin.
Be sure to add a few drops of BabylissPro lubricating oil to the blades before running.
Don’t forget to tighten the screws after the blades have been aligned.
HOW TO USE COMB ATTACHMENTS
To use the comb attachments, turn the clipper to "O-OFF" position.
Slide the comb attachment onto the top of the clipper blade, and then
pull down and over the back of the blade. To remove, pull up on the
back of the comb attachment and then pull away from the blade.
REPLACEMENT (REMOVAL) OF BLADE SET
Step 1. Unplug the unit and adjust the taper lever as shown in Fig. A.
Step 2. Remove the screws and the fixed blade. Save the screws.
Step 3. Lift off the small moving blade and replace it with the new one
on the plastic oscillator (Fig. B).
USER MAINTENANCE INSTRUCTIONS
MAINTENANCE OF THE BLADE
Always apply oil to the blades before, during and after use. This will ensure maximum
cutting performance. Hold clipper away from your body in a downward position and
apply oil on the front and sides of the cutter blade.
Wipe off excess oil with a soft dry cloth. Do not overgrease.
Any other servicing should be performed by an authorized service representative or
that the appliance has no user serviceable parts. The product is for commercial use.
Do not put, twist, or wrap line cord around appliance.
Taper
A.
B.
Small
Moving
Blade
Plastic Oscillator
C.
Fixed Blade
1/32" to 1/16"
Small
Moving
Blade
VERy IMPORTANT: Blades must be cleaned and oiled on a regular basis
to ensure that they will function properly. Failure to regularly clean and
oil the blades will void the warranty.
STORAGE:
When not in use, your clipper should be disconnected and stored in a safe. Dry location,
out of reach of children.
BAB850C IB-11_632B.indd 7-8
1/28/15 2:31 PM
