13
GB
Using your Babyfon
1. Make sure that both devices are switched on and that the same channel is selected.
2. Set the response sensitivity of the microphone on the baby device to the level you
require. To begin with, we recommend a middle position that can later be adjusted
as required.
3. Set the volume on the parent device to the level required. If the baby device is
activated by a noise in the baby's bedroom, transmission starts automatically and the
power-on lamp of the parent device changes from green to red for the duration of the
transmission.
Explanation of functions
Digital pilot tone / preventing interference
Besides the sounds made by the baby, the baby device also transmits an inaudible signal
tone. The parent device only begins reception when this signal tone is received. This
practically rules out the reception of external wireless baby monitors. In rare cases,
however, interference from other wireless devices in the vicinity may occur. In the event
of such interference or poor reception, switch both devices to the other channel.
75 m range
In ideal conditions, the range of your Babyfon outdoors is approx. 75 metres. Obstacles
such as walls, ceilings or large objects affect the range. The more obstacles there are
between the baby and parent devices, the smaller the range becomes.
Using the battery pack supplied
Parent device
1. Remove the belt clip from the device by sliding the clip downwards.
2. Open the battery compartment by loosening the screw on the battery compartment
lid.
3.
Insert the battery pack supplied in the battery compartment, observing the correct
polarity. Make sure that the charging contact has been made in the battery
compartment (see B20 on parent device).
12
GB
4. Slide the battery compartment lid back on to the battery compartment and tighten
the screw again. This ensures that the battery compartment cannot be opened by
accident.
5. To re-attach the belt clip to the device, insert and slide upwards.
6. Connect the AC adapter to the connector on the parent device. The battery pack is
now charged automatically. Charging is complete after approx. 15 hours.
Baby device
The battery pack supplied can also be used for the baby device. Proceed as you did with
the parent device. If you want to power both devices with battery packs, you can order an
additional battery pack (Babyfon® model number EAB 4) from a specialist dealer.
Using other battery packs or batteries
The parent and baby devices can also be powered with standard AAA battery packs or
non-rechargeable 1.5V AAA batteries. However, standard AAA battery packs cannot be
charged using the devices.
Battery alarm
A signal tone and the flashing power-on lamp warn you as soon as the battery pack or
batteries in the parent device are empty. You should then insert new batteries or recharge
the battery pack.
Disposal of batteries
Consider the environment when disposing of the batteries or battery packs, which must
not be thrown away with domestic rubbish. Do not use old and new batteries or different
battery types simultaneously. Remove batteries from the device if it is not to be used for a
long time.
Specifications
No. of channels:
2
Frequency
40.66 – 40.70 MHz
Power supply:
Transmitter:
AC adapter plug 9 Volt/ 200mA
or 4 AAA batteries
(EAB 4 battery pack is available
from specialist dealers)
Receiver:
AC adapter plug 9 Volt/ 200mA
or battery pack EAB 4 (4x AAA
batteries)
(included)
Transmitting power:
max. 10 mW
Operating temperature: 10 to 40° C
Subject to alteration.
Babyfon® is a registered trademark of Vivanco AG, Ahrensburg