Babyauto multimax savile V8A, Instructions For Use Manual

Page: 17 / 21

25
www.babyauto.com
Always check that the harness straps are suitable for the height of
your child. The shoulders of the child should always be just below the
back slots at a suitable height (4.16).
3. Check that the seat belt of the vehicle is passed through the
safety guides and that the belts are not twisted. Insert the safety
seat belt in the vehicle anchor point and press until you hear a
“ click ” so that the child seat is properly installed (4.3).
4. Tighten the lap belt and diagonal shoulder belt, then place the red
safety clip on the diagonal shoulder belt tongue as near to the
vehicle anchor point as possible without touching it! (3.8, 3.9 y
3.10).
5. To unfasten the harness press the red button on the buckle
downwards (4.7).
6. For greater space and to loosen the harness, it is necessary to
press K harness adjustment button, while simultaneously pulling
the harness straps towards you with your other hand (do not pull
the harness protector) (4.8).
7. To recline the seat, pull red seat reclining handle M and pull the base
towards you until the desired position is obtained (4.9).
8. Place the child in the child car safety seat(4.10).
9. Adjust the head support, press headrest adjustment handle Q and
move it up and down until the desired position is obtained (4.11).
10. Adjust the width of the child seat by turning the adjustment knob
of the G laterals and adapt the width of the seat according to the
size of your child by turning the knob (4.12).
11. Join harness tape buckles in buckle-holder, insert both buckles in
child seat buckle-holder and press until you hear a “click” (4.11).
12. Pull harness straps down to ensure both the vehicle belts properly
secure the child seat (4.15).
13. The harness straps should lie comfortably on the child, without
too much slack. It should lie gently on the child without exerting
pressure or causing damage and the child should not be obliged to
assume a bad posture.
IMPORTANT
Group 0+/1/2/3
EN