Babyauto more POLYDU, Instruction Manual

Page: 29 / 52

29
Rev 02
• the Top Tether is tightly tensioned over the backrest of the car seat and the tension
indicator is green.
• the straps of the child safety seat are close to the body without constricting the child.
• the shoulder belts
(D)
are correctly adjusted and the straps are not twisted.
• the shoulder pads (C) are at the same level as your child’s shoulders.
• the buckle latches are engaged in the harness buckle (E) .
4.2 GROUP 1 (9-18 kg). Vehicle belt
1. Make sure that the child seat’s 5-point harness is installed correctly (see
section 7).
2. Follow the steps in section 3.2 ( to adjust headrest).
3. Place the child seat facing in the direction of travel on the vehicle seat.
4. Pull the vehicle belt out and guide it through the belt guides of the child seat.
Make sure that the belt is not twisted (fig.20).
5. Engage the buckle tongue in the vehicle seat buckle this should make a click
noise (fig.21).
6. On the side opposite the car seat belt buckle, press lever (O) and hold down
and insert diagonal belt in belt lock-off (fig.22).
7. Apply your body weight to the child seat (kneel into the seat). At the same
time pull the diagonal belt strongly to tighten .
8. Follow the steps in section securing your child with 5-point harness.
For the safety of your child, before every journey in the car check that...
• the child seat is firmly installed in the vehicle.
• the belt is not twisted.
• the diagonal belt is only clamped by the lock-off which is located on the opposite side
from the car seat belt buckle.
• the straps of the child safety seat are close to the body without constricting the child.
• the shoulder belts
(D) are correctly adjusted and the straps are not twisted.
• the shoulder pads (C) are at the same level as your child’s shoulders.
• the buckle latches are engaged in the harness buckle (E) .
4.3 GROUP 2 (15-25 kg). Vehicle belt+ Top tether
1. Follow the steps in section 4.2 (to fix child seat by three point belt).
2. Take the top tether and if required, lengthen the belt by pressing the top
tether brake button to release the strap, pulling to adjust as necessary
(fig. 23).