Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
8
SAFETY
7
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
ATTATCHING THE SEAT
•
ONLY
approved
SNAP TECH
TM
products can be
used on the frame.
4)
• Attach the seat by lining up the seat
anchors on the side of the seat with the
anchors on the stroller frame and pushing
them together until they lock securely
(Fig. 4).
The seat can face in either
direction, frontward or backward.
• To take off the seat or the infant car seat,
push both release buttons on each side of
the seat anchors and lift the seat upwards.
DO NOT
remove with child in the seat.
TO ADJUST SEAT
5)
• The seats can be adjusted into upright
and reclined positions. Pull the recline
button on the rear of the seat and rotate
the seat into the desired position (Fig. 5).
REMOVABLE CANOPY
6)
•
To attach the removable canopy:
Line
up the posts on the canopy clips with the
holes on the toddler seat tubes. Attach
the canopy to the seat frame using the
hook and loop fasteners (Fig. 6a).
• Push or pull on the front edge of the
canopy while holding the rear of canopy
in place to open and close (Fig. 6b).
Fig. 4
Fig. 5
BRAKES
WARNING:
Always set
brakes when the stroller is not
being pushed so that the stroller
will not roll away. NEVER leave
stroller unattended on a hill or
incline as the stroller may slide
down the hill.
7)
• To engage brakes, apply downward
pressure to the brake levers located on
the rear axle. The stroller might have to
be required to be rolled back and forth
to fully engage the brake (Fig. 7). Check
that the stroller will not move once the
brakes are properly applied. To release,
gently lift up on the brake levers.
TO SECURE THE CHILD
WARNING:
Avoid
serious injury from falling or
sliding out. Always use the
safety harness.
STRANGULATION
HAZARD:
Child can
strangle in loose straps. Never
leave child in seat when straps
are loose or undone.
Fig. 6b
Fig. 6a
Fig. 7
