background image

Before  you  begin:    The  Baby  Trend  Playard  is  designed  so  that,  when 

properly setup, the fabric of the playard places pressure on the 4 top rails 

making them nearly impossible to unlock.  This safety feature is activated 

when you push down on the playard floor to lock the bottom rails.  When 

setting up the playard, if  you allow the bottom rails to lock before locking 

the top rails, the fabric pressure will not allow you to lock the top rails.  

Please see (Fig. 3.) for the proper position of the bottom of the playard 

when locking the top rails.

1.  Unzip bag and remove Playard frame (Fig. 1).  Undo the 3 Velcro 

straps and set mattress aside (Fig. 2). 

2. 

Stand Playard on legs keeping feet of playard close together as shown 

in figure 3.  Pull up on top rails until all rails “click” and “lock”.

*  READ IMPORTANT:  In order to continue, the handle in the 

center of the floor of the Playard MUST remain raised in order  

for the rail to lock (approx. 45.7 cm or 18 inches).  The feet of the 

playard should almost touch each other.  All 4  bottom rails must 

be pointed upward in order to LOCK top rails.

3.  Push down on center of Playard floor until it is flat and locks into  

position (Fig. 4).  The center lock mechanism will lock automatically. 

The center lock will rotate clockwise about 90 degrees as it locks.

NOTE:  Test rails to make sure they are locked.  Push down  on each 

rail making sure they are rigid and in a set position.

WARNING:

 

All top rails MUST be 

straight and locked in position or child may 

become entrapped and suffocate.

 See figure 5 and 6. 

 

4.  Place mattress in Playard with padded side up (Fig. 7).

NOTE:  DO NOT insert mattress if using bassinet feature.  Go to 

bassinet instructions.

5. 

Feed the 6 Velcro straps (found underneath the mattress), 3 on each 

end of the mattress pad, through the slots on the bottom of the sides 

of the Playard.   Fasten the Velcro tabs to the underside of Playard to 

prevent the mattress from moving (Fig. 8) (Fig. 9).

WARNING:

  

To prevent child from 

suffocating, Velcro straps MUST be secured 

to underside of Playard.

6.  Attach the organizer, to any side of the playard, by pushing  the plastic 

clips down over the top rail. (Fig. 10).  The maximum weight capacity 

of the organizer is 3 pounds.

Playard assembly is now complete and ready to use.

Figure 1.

Figure 2.

Figure 3

Figure 4

Figure 5

3

FOR THE SAFETY OF YOUR CHILD, PLEASE READ THE INSTRUCTIONS COMPLETELY 
BEFORE ASSEMBLING THE PLAYARD, BASSINET AND CHANGING AREA

Figure 6

TO ASSEMBLE PLAYARD

Summary of Contents for 8181bt










Reviews: