6
ATTACHMENT OF THE BABY TREND INFANT CAR SEAT
* To attach the Baby Trend Infant Car Seat, remove the seat back reclining
strap and pass the strap through the loop on the side of the seat, repeat
for the opposite side. NOTE: make sure the canopy is pushed forward
then rotate each end of the straps to the inside of the canopy frame.
Please see fi gure 19
*
Check that the front child tray is fi rmly attached to the stroller
armrests.
Pull rearward on the rear edge of the front child tray cover
while lifting upward on the tray cover. Please see fi gure 20 and 21.
Remove the tray cover and store in the pocket in the rear of the seat.
Please see fi gure 22.
* Position the Infant Car Seat, facing toward the rear of the stroller, so
that the seat shell goes into the front tray and latches into place. The
sides of the car seat will rest on fold joints. Please see fi gure 23.
* Bring the seat back reclining strap through the inside of the canopy
frame and pass it through the seat belt slots on the car seat. Snap the two
ends together and tighten for a snug fi t. Please see fi gure 23a.
Check that the Infant Car Seat is fi rmly locked onto the front tray
before using.
* To remove the Infant Car Seat, squeeze the release handle located at the
foot-end of the seat and carefully lift upward on the seat. Please see
fi gure 23b.
Figure 19.
Figure 20.
Figure21.
Figure 22.
Figure 23.
Rest on
fold joints
Locks
into tray
Figure 23a.
Figure 23b.
WARNING:
Failure to
follow these car seat attachment
instructions could result in seri-
ous injury or death.
