* Remove stroller from box. The front wheels, rear wheels, child tray, parent
tray, and canopy need to be installed prior to use.
* To attach the front wheels, unfold stroller as described in the section
following. See fi gure 1.
* Lean the stroller backwards so that it rests on the handle and rear frame
tubes and the front wheel tubes are pointing upward. Position the front
wheel assembly at the front tube such that the hole in the swivel assembly
will slide onto the front tube. Please see fi gure 2. Push each front wheel
assembly onto the front tube being careful that wheel assembly locks onto
the front leg. Pull on the wheel assembly to ensure that it is securely
attached to the stroller. Please see fi gure 2.
* Lean the stroller forward to rest on the front wheels. Assemble the rear
wheels as follows:
1. Slide the rear wheel housings onto each rear stroller leg until locked
into place. The push button on the forward edge of the leg should
snap into the hole in the housing. Please see fi gure 3.
2. Slide the rear axle through the housings as shown in fi gure 4.
3. Slide each wheel onto the rear axle and secure in place with the
Locking Cap. Snap the solid cap over the Locking Cap. Snap the
Hub Cap onto the wheel. Please see fi gure 5. Please see fi gure 6 for
order assembly.
Pull on each wheel to ensure that each is fi rmly attached to the axle.
* Ensure that the wheels are fi rmly locked into place. Do Not use the stroller
if the wheels are not locked into place, but rather contact our customer
service department immediately at (800) 328-7363, between the hours of
8:00am and 4:30pm PCT, for assistance.
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE
INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Car Seat
Front Wheels
Figure 3.
Parent Tray
PARTS
TO ASSEMBLE STROLLER
Slide axle through
Figure 5.
Child Tray
Figure 4.
Rear Axle
Solid Cap
Locking Cap
Rear Wheels
Figure 6.
Stroller
Figure 1.
Base
Car Seat
Figure 2.
Rear Wheel Housing
Hub Cap
Front Wheels
3
