![background image](http://html1.mh-extra.com/html/baby-lock/regent-blrt18/regent-blrt18_instruction-and-reference-manual_3420000016.webp)
14 |
www.BabyLock.com
Installing the Power Cord
Check that the On/Off switch is turned off
(the 0 setting). Plug the power cord into the top power
outlet on the back of the machine. Do not plug the
power cord into a power source at this time.
The lower power connector is available for powering
future attachments as they are developed by Baby Lock
(none yet available).
Installing the Foot Pedal
1. Plug foot pedal cord end into the foot pedal connector that is attached to the Regent Quilting Table.
2. Place the foot pedal under the table where operator can reach it from the front of the machine.
Installing the Thread Mast
1. Locate the threaded hole on top of the machine near
the rear by the hand wheel.
2. The thread mast comes with a washer and a nut.
Remove the nut and washer, replace the nut onto the
mast for five or six turns.
3. The washer protects the painted surface when the nut
is tightened. Place the washer on the hole and insert
the thread mast.
4. Turn the thread mast clockwise several revolutions,
stopping when the mast eyelets are positioned directly
over the spool pins.
5. Tighten the nut to secure the mast to the machine.
NOTE:
The eyelets of the thread mast MUST be
centered over the spool pins. This ensures that the
cone of thread will not pull, turn or tilt, which will
cause thread tension problems.