Baby Lock Pro-Stitcher Premium BLPS6, Installation Manual

Page: 14 / 32

www.babylock.com
BLPS6 - CJ Installation Guide
| 3.7
U
CAUTION: Do not use the larger drill bit included in the emergency repair kit, as this is
the wrong size for the Flexirack clamps.
NOTE: As an alternative, use one clamp at each end. Slide the lip of the clamp over the
last gear of the blue Flexirack, drill a pilot hole, and screw in place.
To install the Y-Rack
7. Carefully lay the quilting machine on its power
pod side (the left side, looking from the front).
U
CAUTION: Pay close attention to the
Y-encoder mounted to the rear left wheel so
you do not damage the Y-encoder bracket.
Underneath the base plates, near the wheels
on the C-pod side of the machine (the side with
the thread tensioner and guides) there will
be either two screws or two holes. If the
screws are there, use a large flat screwdriver
to remove the screws.
8. Attach the Y-Rack to the bottom of the front and
rear base plates. The blue Flexirack should be
toward the middle of the machine while the bolt
holes should be toward the outside. Use the
screws that were removed from the front and rear
base plates (or use the two smallest screws in
the Base Plate Repair Kit [see Parts List, item D]
if your machine had no screws here).
U
CAUTION: Be careful not to over-tighten the screws as the base plate holes will strip
easily. In case of accidentally cross-threading or stripping one of the base plate holes, an
emergency repair kit (see Parts List, item D) has been provided.
9. If the screws in the base plates do not have slotted heads and a nut driver cannot be fitted
over the screw head, use one of the provided slotted screws as a replacement (see Parts
List, item D) and use a slotted screwdriver to tighten the screws in place.