S
E
R
G
E
R
S
E
T
U
P
11
Upper Looper
1
"
(2
.5
c
m
)
Looper Threader Lever
D
18" (45cm)
B
2
B
C
3
2
A
1
C
1. With the presser foot up and machine lock button in the locked position (see fig. A, page 10), set the
looper threader selector lever to "U" for upper looper threading. (See fig. B, page 10.)
2. Place the thread cone or spool on the second spool pin from the right. Slip the thread into the telescop-
ic antenna thread guide "A" directly above the spool, snap into the thread guide "B" at the top of the front
of the machine, through the slot on the front cover. (See fig. C, below.)
3. Pull 18 inches (45cm) of thread through guide "C". Insert the end of the thread into the threading port "U",
about 1 inch (2.5cm). Use tweezers, if necessary, to insert the thread end more easily. (See fig. D below.)
4. Depress the looper threader lever (fig. D below) . If the thread does not go through the upper looper eye
with one push, depress the looper threader lever again until it does, and leave thread hanging loose.
5. Move the lock button release lever to the right.
*B
e sure at least 1" of thread is inserted into the threading port.
Summary of Contents for imagine BLE1AT-2
Page 1: ...Model BLE1AT 2 Instruction Manual Vol 1 0...
Page 54: ...EI E BLE1AT 2 TA...
