S
E
R
G
E
R
S
E
T
U
P
10
Threading Your Imagine
Locked Position for Threading
Lower Looper
Lock Button
Release Lever
Machine Lock
Button
A
Looper Threader
Selector
B
Your Baby Lock Imagine is equipped with an exclusive "Instant Jet-Air Threading System" for fast, easy
threading of the upper and lower loopers.
One push of the "Jet-Air" threading lever will automatically thread the loopers. It is no longer necessary to
use tweezers for threading the thread guides.
If a thread breaks or runs out, just re-thread it. There is no need to follow any threading sequence.
1. Open the front cover.
2. Raise the presser foot to release all threads.
3. Depress the machine lock button firmly. Rotate the machine handwheel slowly toward you until the
button "snaps" into the locked position and the lock button release lever moves to the far left (fig.A).
Note:
The Imagine Wave must be in the locked position when threading the loopers unless otherwise
indicated.
1. With the presser foot up and machine lock button in the locked position (fig. A) , set the looper threader
selector lever to "L" for lower looper threading (fig. B).
2. Place the thread cone or spool on the far right spool pin. Slip the thread into the telescopic antenna thread
guide "1" directly above the spool, snap into the thread guide "2" at the top of the machine, through the
slot on the front of the machine. (See fig. C page 11)
3. Pull 18 inches (45cm) of thread through guide "3". Insert the end of the thread into the threading port "L"
about 1 inch (2.5cm) . Use tweezers if necessary, to insert the thread end more easily.
4. Depress the looper threading lever (fig. D page 11) . If the thread does not go through the lower looper
eye with one push, depress the threading lever again until it does.
5. Clip the thread 4 inches (10cm) from the lower looper eye and leave it hanging loose.
6. Move the lock button release lever to the right.
Summary of Contents for imagine BLE1AT-2
Page 1: ...Model BLE1AT 2 Instruction Manual Vol 1 0...
Page 54: ...EI E BLE1AT 2 TA...
