Baby Lock Ellisimo GOLD BLSOG, Instruction And Reference Manual

Page: 75 / 364

SEWING
Se
wi
n
g Ba
sics
73
2
f
Adjust the sewing speed with the speed
control slide.
* You can use this slide to adjust sewing speed during
sewing.
a Slow
b
Fast
g
Press the “Start/Stop” button to start
sewing.
* Guide the fabric lightly by hand.
h
Press the “Start/Stop” button again to stop
sewing.
i
Press the “Thread Cutter” button to trim
the upper and lower threads.
→
The needle will return to the up position
automatically.
j
When the needle has stopped moving, raise
the presser foot and remove the fabric.
■
Using the Foot Controller
You can also use the foot controller to start and stop
sewing.
Memo
• When the foot controller is being used, you
cannot start sewing by pressing the “Start/
Stop” button.
CAUTION
• Do not press the “Thread Cutter” button after
the threads have been cut. Doing so could
tangle the thread or break the needle and
damage the machine.
• Do not press the “Thread Cutter” button when
there is no fabric set in the machine or during
machine operation. The thread may tangle,
possibly resulting in damage.
Note
• When cutting thread thicker than #30, nylon
monofilament thread, or other decorative
threads, use the thread cutter on the side of
the machine.
Memo
• This machine is equipped with a bobbin
thread sensor that warns you when the bob-
bin thread is almost empty. When the bobbin
thread is nearly empty, the machine auto-
matically stops. However, if the “Start/Stop”
button is pressed, a few stitches can be
sewn. When the warning displays, re-thread
the machine immediately.
CAUTION
• Do not allow fabric pieces and dust to collect
in the foot controller. Doing so could cause a
fire or an electric shock.
Memo
• When the foot controller is being used, you
cannot start sewing by pressing the “Start/
Stop” button.
• The foot controller cannot be used when
embroidering.
• The foot controller can be used for sewing
utility and decorative stitches when the
embroidery unit is attached.