Upper Threading
25
1
Threading the needle
This section describes how to thread the needle.
Note
●
The needle threader can be used with
sewing machine needles 75/11 through
100/16.
●
Thread with a thickness of 130/20 or thicker
cannot be used with the needle threader.
●
The needle threader cannot be used with
the wing needle or the twin needle.
●
If the needle threader cannot be used, refer
to “Threading the needle manually (without
using the needle threader)” (page 26).
1
Pull the end of the thread passed through the
needle bar thread guide to the left, and then
pass the thread through the thread guide disk
from the front.
1
Thread guide disk
2
Cut the thread with the cutter on the left side
of the machine.
1
Cutter
Note
●
If the thread is pulled through and cannot
be cut correctly, lower the presser foot so
that the thread is held in place before
cutting the thread. If this operation is
performed, skip step
3
.
●
When using thread that quickly winds off the
spool, such as metallic thread, it may be
difficult to thread the needle if the thread is cut.
Therefore, instead of using the thread cutter,
pull out about 80 mm (approx. 3 inches) of
thread after passing it through the thread
guide disks (marked “7”).
1
80 mm (3 inches) or more
3
Lower the presser foot lever to lower the
presser foot.
1
Presser foot lever
4
Lower the needle threader lever on the left
side of the machine until it clicks, and then
slowly return the lever to its original position.
1
Needle threader lever
X
The thread is passed through the eye of the
needle.
1
1
1
1
1
Summary of Contents for Crafter's Choice BLCC2
