16 |
www.babylock.com
3.
Slide the two bolts into holes until they stop. Hand tighten, and then use the 4 mm wrench to securely
fasten the handles to the back of the machine.
4.
After the two bolts are in place, plug the small connector end of the cable into the port on the left side
of the display. Push the plug securely into place.
5.
Securely plug the other end of the cable into the port on the back of the machine below
the handlebars.
NOTE: See the instructions that accompany the Rear Handlebars and Display.
Â
IMPORTANT: After the rear handlebars have been completely installed and plugged in, test them by
turning on the Baby Lock Coronet and looking at the rear display. I
f nothing appears on the screen,
check that both the front and rear handlebar cables are plugged in securely, that your machine is
turned on, and that the power cord is plugged into the machine as well as a power source.
Thread Antennae
To install the thread antennae
1.
Locate the threaded hole on top of the machine by
the handwheel.
2.
The thread antennae comes with a washer and a
nut. Remove the nut and washer, replace the nut
onto the antennae for two or three turns.
3. Place the washer on the hole and insert the thread
antennae. The washer protects the painted surface
when the nut is tightened.
4. Turn the thread antennae clockwise several
revolutions, stopping when the antennae eyelets are
positioned directly over the spool pins.
5. Tighten the nut to secure the antennae to the
machine.
