Re-threading Loopers
Re-threading Needles
If a thread breaks, raise the presser foot and pull the broken thread out from under the foot. Open
the front cover, depress the machine lock button and set the looper threader selector to U or L for
the looper being threaded. Re-thread the machine above the threading port, leaving an 18inch
(45cm) thread tail. Thread the looper as usual and move lock button release lever to the right.
Close the front cover and sew a test sample. Refer to page 14-15 for further information.
Note:
When re-threading your baby lock enspire using the "Jet-Air Threading" feature, make sure
that the previous thread that was in the looper (tube) is completely removed. This will elim-
inate any chance of the previous thread obstructing the flow of the air when re-threading the
machine.
If a needle thread breaks, raise the presser foot, remove the broken thread and rethread the
needle thread guides. Turn the handwheel and line up the green marks on the handwheel and
machine. Select the "R" or "L" for the needle being rethreaded. Use the needle threader for exact
and easier threading. Refer to pages 16-17 for further information.
20
T
H
R
E
A
D
I
N
G
Summary of Contents for BLE1EX
Page 1: ...Model BLE1EX...
