Baby Jogger CITY MINI GT 2, Assembly Instructions Manual

Page: 12 / 24

12
FRAME
1 Unpack the stroller frame from the box
and set the wheels aside .
Unlock the stroller by pulling the auto-
lock lever .
2 Unfold the stroller by pulling the
handlebar away from the frame . The
stroller will lock into place and you will
hear a click .
3 Place the stroller in the upright
position .
WARNING: Ensure that all the locking
devices are engaged before use .
FRONT WHEEL
4 Installation
• Lay stroller on its back so the
handlebar is resting on the floor .
• Attach front wheels by sliding them
into the front wheel mount until it
clicks . Gently pull on the front wheel
to make sure it is properly attached .
5 Removal
• While pressing the front wheel release
button, gently slide the front wheel out
of the front wheel mount .
SWIVEL FEATURE
6 Push the swivel button down and
rotate to the left to lock the front wheel
assembly in a fixed position for long
distance strolling.
7 Push the swivel button down and
rotate to the right to allow the front
wheel assembly to swivel.
WARNING: When loading and
unloading child, lock the front wheel
in a fixed position . Although the
front wheel of your stroller locks, it is
not intended for jogging or exercise
purposes .
REAR WHEELS
8 Installation
• Align the rear wheel axle with the
wheel mount on the stroller frame and
insert it into the wheel mount until it
locks into place . You will hear a click .
• Gently pull on the rear wheel to make
sure it is properly attached .
9 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount .
HANDLE
10 Press the handle release buttons on
both sides and rotate up or down to
the new position .
BRAKE
11 To Lock the Brakes: gently pull the
Brake Lever into upright position until it
clicks into place.
12 To Release the Brakes: Pinch the gray
tabs and pull the lever towards you.
Push the Brake Lever down until it is
parallel with the frame.
WARNING: Lock the brakes before
loading and unloading your child and
whenever the stroller is not moving .
CANOPY
13 Attach the canopy to the frame by
sliding the canopy onto the mounting
brackets . To remove, slide canopy off
of mounting brackets .
NOTE: When using a Car Seat, canopy
must be removed .
14 Snap the 3 snaps to the stroller frame .
15 Attach the fastening strip on the back
of the canopy to the frame .
16 Pull forward to open canopy and push
backwards to close canopy .
17 There are two canopy windows, a top
one and back one . To use them, roll
the shade up towards the top and
secure with the elastic and button .
ADJUSTING SAFETY HARNESS
18 From the back of the seat, undo the
fastening strip and open the pocket to
locate the plastic square stopper . Turn
stopper and pass through the openings
in the PE board and seat fabric .
19 Reinsert stopper at seat opening
closest to child’s shoulders . Pass back
through seat fabric and PE board . Tug
on strap to ensure stopper is locked .
Repeat on both sides .
EN