Baby Jogger CITY MINI 2, Assembly Instructions Manual

Page: 11 / 147

11
EN
FRAME
1 Unpack the pushchair frame from
the box and set the wheels aside .
Unlock the pushchair by pulling the
storage lock lever .
2 Unfold the pushchair by pulling the
handlebar away from the frame .
3 The pushchair will lock into place
and you will hear a click .
WARNING: Ensure that all the
locking devices are engaged before
use .
FRONT WHEELS
4 Installation
• Lay pushchair on its back so the
handlebar is resting on the floor .
• Attach the front wheel by sliding
it into the front wheel mount until
it clicks . Gently pull on the front
wheel to make sure it is properly
attached .
5 Removal
• While pressing the front wheel
release button, gently slide the
front wheel out of the front wheel
mount .
SWIVEL FEATURE
6 Press the Swivel Lock button down
and slide the Swivel Lock to the left
to lock the front wheel assembly
in a fixed position for long distance
strolling .
7 Press the Swivel Lock button
down and slide the Swivel Lock to
the right to allow the front wheel
assembly to swivel .
WARNING: When loading and
unloading child, lock the front
wheels in a fixed position . Although
the front wheels of your pushchair
lock, it is not intended for jogging or
exercise purposes .
REAR WHEELS
8 Installation
• Align the rear wheel axle with the
wheel mount on the pushchair
frame and insert it into the wheel
mount until it locks into place . You
will hear a click .
• Gently pull on the rear wheel to
make sure it is properly attached .
9 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount .
BRAKE
10 To lock the brakes: push the brake
lever down to engage the brakes .
11 To release the brakes: lift the brake
lever up .
WARNING: Lock the brakes before
loading and unloading your child
and whenever the pushchair is not
moving .
CANOPY
12 Attach the canopy to the frame by
sliding the canopy onto one of two
mounting brackets . To remove, slide
canopy off of mounts .
NOTE: When using a City Go/
Graco or Britax car seat, the
canopy must be in the top
position . For all other car seats,
canopy must be removed .
13 Snap the two snaps to the
pushchair frame .
14 Zip the back of the seat to the
canopy top
.
Attach the 2 fastening strips on the
side of the canopy
.
15 Pull forward to open canopy and
push backwards to close canopy .
16 There are two canopy windows, a
top one and back one . To use them,
roll the shade up towards the top
and secure with the elastic and
button .
ADJUSTING SAFETY HARNESS
17 From the back of the seat, unfasten
and open the pocket to locate the
plastic square stopper . Turn stopper
and pass through the openings in the
PE board and seat fabric .
18 Reinsert stopper at seat opening
closest to child’s shoulders . Pass
back through seat fabric and PE
board . Tug on strap to ensure
stopper is locked . Repeat on both
sides .
WARNING: Avoid serious injury from
falling or sliding out . Always properly