NOTES:
14
13
Machine has not been cleaned regularly.
Make sure silicone scraper is installed correctly.
Not enough powder
dispensed.
Condition
Possible Cause
Possible Remedy
Refill Powder Container with more powder.
Powder level in powder container is too low.
Silicone scraper is not correctly installed.
Measuring wheel is set to incorrect number
for powder type.
Make sure the measuring wheel is set to the correct
number for your powder type. See page 5, Steps 1-2a.
Too much powder
dispensed
Measuring wheel is set to incorrect
number for powder type.
Make sure the measuring wheel is set to the correct
number for your powder type. See page 5, Steps 1-2a.
Locking cover is not under tab in
powder container.
Check locking cover and make sure the front edge is
locked under the tab in the powder container.
See page 6, Step 5 for details.
Not dispensing water
Water Tank not fully seated.
Push Water Tank down all the way on Base.
Powder Container Parts stuck
Not dispensing water or formula.
Yellow and Green Temp LEDs flash
when start is pressed.
Water Tank not fully seated.
Push Water Tank down all the way on Base.
Clean heater plate and use mineral free water if
possible.
Scaling on water tank heater plate.
Mineral rich water used persistently.
Powder build-up on funnel cover and
underside of powder container.
Clean funnel cover and powder container bottom
frequently after every 4 bottles.
Frequent use without cleaning underside
of powder container. See page 9, Step 3 for
details.
Turn off power, remove powder from Powder
Container, check for and clear any obstructions,
turn power back on and resume normal use.
Water Tank is full, red no
water light is on.
TROUBLESHOOTING
Disassemble, clean by hand-washing, completely
dry all parts and reassemble.
If you can not remedy problems with the machine by using the troubleshooting chart above,
please contact Customer Service at: [email protected]