SUBTERRA
Page 5
www.babcopark.ca
Third, Finish installation of top platform, run a few test lifts, then find level by tightening bolt., ensure that the lift
is operating smooth and level.
2.
OPERATION MANUAL
2.1
BEFORE OPERATION:
Read the entire manual before operation
The lift may only be used by qualified staff, properly trained for the specific use of the machine.
1)
Check all the pipelines, joints and safety devices are functioning before use. When malfunctions or leakage is
found, have maintenance performed before operating the lift.
2)
Ensure that the danger zone as described in the safety section is clear of people and obstacles while the lift is
being operated. Make sure that there are no people on the platforms during up and down movements.
3)
During operation, ensure that the operator remains at the control station and everyone else is away from the
lift surroundings.
Never leave the lift unattended when in the UP position as a person could easily go under the lift.
Before lowering the lift, the operator should check and confirm that no person is under the lift.
4)
Make sure that the vehicle is positioned correctly according to the parking position schematic in the technical
section. Switch off the engine of the vehicle, put in gear (if applicable) and engage the parking brake. Be sure
to lift only approved vehicles, never exceeding the specified weight and maximum height, length and width as
specified in the technical section.
5)
Ensure that sufficient lighting is available for good visibility, without any shadows or blind spots.
6)
Ensure that enough height is available for clearance above the vehicle.
7)
Always lower the lift to its lowest position after use.
Please use the following checklist for operation:
2.2
CHECKLIST FOR RAISING THE LIFT:
1)
Check and confirm that nobody is in the vicinity of the lift.
2)
Check that the lift is free of obstacles, and enough height is available.
3)
Turn on the key and red master shutoff knob
4)
Engage the “UP” switch and release. Make sure the lift will stop at the correct height.
5)
After the lift stops, turn off the master shutoff.
6)
Turn off and store the key.
2.3
CHECKLIST FOR LOWERING THE LIFT:
1)
Check correct position and securement of vehicle
2)
Check and confirm that nobody is in the lift vicinity.
3)
Check that nobody is under the lift.
4)
Check that the lift is free of obstacles.
